The function and quality of the rubber conveyor belt are increasing
Ring rubber conveyor belt thinning, not easy to lap. The damage of the surface of the conveyor belt, so that the thickness of thin, in the two ends of the lap, the connector thickness varies, in the operation of the joint position and the roller to produce a strong scratch, both wear roller, but also shorten the joint life , Especially the new band with the old band is more prominent lap. For the use of curing connection conveyor belt, because the thickness is not the same, the overlap is more difficult. Damage to a certain extent, especially after the cover layer deep and core layer, a direct impact on the conveyor belt tensile strength, so that the strength decreased. Conveyor belt life is shortened, reducing the service life of the conveyor belt, increasing the cost of transportation of the mine. For the rubber conveyor belt on both sides of the center line wear degree of different conveyor belt, due to the local tensile strength has changed, but also further reduce the service life of the conveyor belt.
The relationship between the diameter of the transmission drum of the oil-resistant rubber conveyor belt and the conveyor belt, the matching of the drive roller and the reel roller, and the requirements for the roller groove angle should be selected according to the design requirements of the conveyor. The direction of feeding should be along the conveyor belt running direction, in order to reduce the impact of the material when the conveyor belt should be chute, reduce the material gap; conveyor belt by the material, should reduce the roller spacing and the use of buffer roller Material, rubber conveyor belt to adapt to the use of soft and moderate baffle plate, so as not to file board too hard, scraping the conveyor belt with the surface. To prevent the conveyor belt from starting. Conveyor belt deviation, should take timely measures to correct. Different types, specifications of the number of conveyor belt should not be used together, the joint is best to use glue method. Conveyor belt type, structure, specifications, layers should be based on the use of reasonable selection. Conveyor belt operating speed should not be greater than 2.5m / s, large block, large wear materials and the use of fixed pear discharge device should be used as low as possible.

[last] How to prevent the stripping of the conveyor belt [next] Rubber conveyor belt bending discount reasons

Copyright © 2016 BaoDing City Jing Bo Rubber Co., LTD. All Rights   Email:info@hbjingbo.com